Payment & Shipping Terms:
|Type:||SMD LED||Chip Material:||InGaN|
|Emitting Color:||Purple||Luminous Intensity:||Customers' Requirements|
|Viewing Angle(°):||120 Degree||Color Rendering Index:||70|
|Color Temperature:||6000-6500K||Operating Temperature:||-20 - 85|
|Chip Brand:||Epistar Chip, Sanan Chip,Epileds Chip||Current:||150mA|
5050 nail lamp led chip
Sanan / Epistar
0.2w / 0.5w / 1.0w
LM-80 50000 Hours Tested 5050 SMD LED
1. High Lumens Output & Low Brightness Decay
2. Stable Performance & Great CCT Inity.
3. Wid Color Temperature Range
4. good raw materials
5. Taiwan Epistar, Xianmen San'an chips
1. 99.9% gold wire
2.Taiwan red copper holder good cooling
3.high brightness Sanan Epistar led chip
Original factory formal chip more stable
4.High refractive index silicone
Absolute Maximum Rating
Pulse Forward Current
-40ºC To +85ºC
-40ºC To +85ºC
Reflow Soldering: 260ºC
Hand Soldering : 350ºC
Carrier Tape Dimensions:
Loaded quantity 800 PCS Per reel.
Please read the following notes before using the product:
Customer must apply resistors for protection, otherwise slight voltage shift will cause big current change (Burn out will happen).
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 The LEDs should be used within a year.
2.4 After opening the package, the LEDs should be kept at 30℃ or less and 70%RH or less.
2.5 The LEDs should be used within 168 hours (7 days) after opening the package.
2.6 If the moisture adsorbent material (silica gel) has fabled away or the LEDs have exceeded the storage time, baking treatment should be performed using the following conditions. Baking treatment: 60±5℃ for 24 hours.
3. Soldering Condition
3.1 Pb-free solder temperature profile.
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 260℃ for 5 seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal. Be careful because the damage of the product is often started at the time of the hand solder.
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
We provide EMS DHL UPS FedEx TNT that several different types of express allows you to select, under normal circumstances, the transport time is in 5 to 10 days or so, if large cargo, go shipping, so time is longer, but safer, and the freight is lower.
Are widely used in the LED lamp, LED bulb light, LED panel light, LED ceiling lamp, LED street light, LED lamp, miner's lamp, stage light, flashlight, lighting, lamp lighting lamps and lanterns, as well as outdoor billboards, such as electronic display, traffic lights, signs, car tail lights, LED modules, LCD back light, LED lighting lighting, LED soft/hard light bar, etc., is the better choice to replace traditional lighting light source.